RC Media

Tips for R/C

Translation from Team Zarashi :

OP-001
Hops Ups Parts for TRF501X
Tend to occur when running a lot of surface dust and sand
To prevent the entry of foreign material into RIYADEFU part, or loss of Def
Greatly reducing the risk of breakage of the belt.

Incorporation plastic glass.

OP-001 TRF501X explains how mounting.

The breakdown left rear bulkhead of the body parts.
Please set a provisional bulkheads set covers the front of the gear.
Sitting in a bad part of the arrow, you may not adhere to the bulkhead.

If so, please turn the arrow of Bali.

After deburring is such a state.

When there is a flash in the arrow may be contacted, please spare belt.

Tentatively set to the rear then.
Clearance of the belt and pulley covers are quite rasp.
If you contact the pulleys to cover at this stage is to move some adjustments Pulley Shim
Please YASURI in shaping the coverage.

Bali may be part of the belt and the rear exit.
Please do not contact with the orthopedic belt.

A condition attached to the bulkhead cover.
Please check again if there are any areas in contact with the belt pulley.
When MINAOSU the body, the position of the cover is in contact with the provisions SASUMAUNTOFURONTO
If not, please attach a knife surgery in the contacts.

It is fully completed MINAOSHI body.

Source : Team Zarashi

You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.